Simulation Details
- Input File:
movie_037.inp
- Output File:
movie_037.out
- Plot Type: Color plot
- Variable Plotted: Stress in the x-direction (S11)
Simulation Description
The simulation is a 3D dynamic analysis of an isolated dinosaur model, with the following key points:
- Model Parameters:
- Material: Aluminum alloy 6061-T6
- Geometry: Dinosaur model created using LS-DYNA's PREPOST module
- Mesh: Linear tetrahedral elements (TET4)
- Boundary Conditions:
- Fixed supports on the bottom face of the dinosaur
- Free boundaries on all other faces
- Load Case:
- Dynamic load applied to the top face of the dinosaur using a rigid body impactor
- Load magnitude: 1000 N
- Duration: 10 ms
-
Simulation Results:
- Maximum stress in the x-direction (S11) reaches approximately 200 MPa at the center of the dinosaur's back
- Stress distribution appears to be symmetric about the vertical axis, with higher stresses near the top and lower stresses near the bottom
|