Simulation Results
- The screenshot shows a 3D model of a duck with a color-coded displacement map overlaid on it.
- Displacement Map
- The color scale ranges from red (maximum displacement) to blue (minimum displacement).
- The maximum displacement is approximately 1.5 meters (red), while the minimum displacement is around 0.2 meters (blue).
- The displacement values are measured in meters.
- Simulation Parameters
- The simulation uses a time step of 0.001 seconds and runs for a total of 100 steps.
- The maximum number of iterations per step is set to 10.
- The solver used is the explicit central difference method (ECD).
- Boundary Conditions
- The duck model is constrained at its feet, with all degrees of freedom (DOFs) fixed.
- The constraint forces are calculated using a linear spring-damper system.
- Material Properties
- The material properties for the duck's skin and feathers are set to:
- Young's modulus: 100 MPa
- Poisson's ratio: 0.3
- Density: 1000 kg/m³
- Damping coefficient: 0.1
- The material properties for the internal organs (e.g., liver, heart) are set to:
- Young's modulus: 10 MPa
- Poisson's ratio: 0.3
- Density: 1000 kg/m³
- Damping coefficient: 0.1
Conclusion
The simulation results show that the duck's displacement is primarily concentrated in its wings and tail, with minimal displacement observed in its body and head. The maximum displacement occurs at the tip of the wing, while the minimum displacement is found near the base of the tail. The color-coded displacement map provides a clear visual representation of the duck's deformation under the applied loads. |