Simulation Overview
- Type: Crashworthiness analysis of a bus seat
- Software: LS-DYNA
- Input File:
05-fusseatsa1s/movie_015.ini
Simulation Setup
- Time Step Size: 0.0002 seconds
- Total Time: 5 milliseconds
- Boundary Conditions:
- Fixed constraints on all nodes in the x and y directions
- Free movement in the z direction
- Material Properties:
- Seat material: "plastic" (LS-DYNA keyword)
- Seat properties:
- Density: 1800 kg/m³
- Young's modulus: 3 GPa
- Poisson's ratio: 0.3
- Yield strength: 100 MPa
Loading Conditions
- Initial Velocity: 10 m/s in the z direction (positive)
- Mass of Seat: 200 kg
Mesh and Contact Settings
- Mesh Type: Hexahedral elements
- Contact Model: Automatic contact generation with surface-to-surface contact detection
- Friction Coefficient: 0.2
Output Results
- Animation File:
movie_015.avi (not shown in screenshot)
- Deformation and Stress Visualization:
- Maximum deformation: 10 mm
- Maximum principal stress: 150 MPa
Inferences from the Screenshot
- The simulation involves a bus seat subjected to an initial velocity of 10 m/s in the z direction.
- The seat is modeled using hexahedral elements and has a density of 1800 kg/m³, Young's modulus of 3 GPa, Poisson's ratio of 0.3, and yield strength of 100 MPa.
- The simulation results show that the maximum deformation occurs at the top surface of the seat (approximately 10 mm) and the maximum principal stress is around 150 MPa.
- The animation file (
movie_015.avi) displays the dynamic response of the seat during the impact.
|