LS-DYNA > Movies > 2022-06-21 > 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176 177 178 179 180 181 182 183 184 185 186 187 188 189 190 191 192 193 194 195 196 197 198 199 200 201 202 203 204 205 206 207 208 209 210 211 212 213 214 215 216 217 218 219 220 221 222 223 224 225 226 227 228 229 230 231 232 233 234 235 236 237 238 239 240 241 242 243 244 245 246 247 248 249 250 251 252 253 254 255 256 257 258 259 260 261
165. hole2a/movie_083a.mp4

Download movie as MP4 or WebM.


AI-generated description:

LS-DYNA simulation shows stress/deformation around a circular hole (10-15 cm) in steel/aluminum. Color-coded results highlight high (red), moderate (green), and low (blue) stress areas, aiding material design optimization for improved structural integrity.

The image shows a 3D representation of the deformation and stress distribution around a hole in a material, likely steel or aluminum. The hole is circular and has a diameter of approximately 10-15 cm.

Visualization

  • The simulation was run using LS-DYNA software, which is a commercial finite element method (FEM) solver.
  • The visualization is based on the results of the simulation, showing the deformation and stress distribution around the hole in real-time.

Deformation Patterns

  • The material around the hole has deformed significantly, with large displacements and rotations observed at the free surface.
  • The deformation patterns indicate that the material is experiencing high stresses and strains, particularly near the edge of the hole.
  • There are some areas where the material appears to be buckling or folding under stress.

Color Mapping

  • The color mapping used in the visualization represents different aspects of the simulation results:
    • Red: indicates regions of high stress or strain
    • Blue: indicates regions of low stress or strain
    • Green: indicates regions of moderate stress or strain

Conclusion

The LS-DYNA simulation "hole2a/movie_083a.mp4" provides valuable insights into the behavior of materials under complex loading conditions. The visualization highlights areas of high stress and deformation, which can be used to optimize material design and improve structural integrity.