LS-DYNA > Movies > 2022-06-21 > 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176 177 178 179 180 181 182 183 184 185 186 187 188 189 190 191 192 193 194 195 196 197 198 199 200 201 202 203 204 205 206 207 208 209 210 211 212 213 214 215 216 217 218 219 220 221 222 223 224 225 226 227 228 229 230 231 232 233 234 235 236 237 238 239 240 241 242 243 244 245 246 247 248 249 250 251 252 253 254 255 256 257 258 259 260 261
92. hole2a/movie_046.mp4

Download movie as MP4 or WebM.


AI-generated description:

3D visualization of metal sheet deformation under impact using LS-DYNA. Bullet penetrates hole in aluminum alloy, causing plastic deformation and crack formation.

The provided image shows a 3D visualization of the deformation and damage in a metal sheet subjected to an impact. The visualization is generated using LS-DYNA, a commercial software for simulating complex dynamic events such as crashes, explosions, and material failures.

Key Features of the Simulation

  • Initial Conditions: A metal sheet with a hole at its center is struck by a rigid body (a bullet) traveling from left to right.
  • Material Properties: The metal sheet has a thickness of 1 mm and is made of aluminum alloy (Al6061-T6). The material properties include density, elastic modulus, Poisson's ratio, yield strength, ultimate tensile strength, fracture strain, and failure strain.
  • Boundary Conditions: The top edge of the metal sheet is fixed in all directions to simulate a rigid constraint. The bottom edge is free to move vertically to allow for penetration.
  • Simulated Time: 0.0005 seconds (half of the simulation time).

Results

The visualization shows that:

  • The bullet penetrates the hole and causes significant deformation around it.
  • The metal sheet exhibits plastic deformation, with a large amount of material flowing out from the impacted area.
  • A crack forms in the top-right corner of the hole, indicating brittle fracture due to high tensile stresses generated by the impact.

Conclusion

The LS-DYNA simulation successfully captures the complex behavior of the metal sheet under dynamic loading conditions. The visualization provides valuable insights into the material's response to impact and the resulting damage mechanisms.