LS-DYNA > Movies > 2022-06-21 > 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176 177 178 179 180 181 182 183 184 185 186 187 188 189 190 191 192 193 194 195 196 197 198 199 200 201 202 203 204 205 206 207 208 209 210 211 212 213 214 215 216 217 218 219 220 221 222 223 224 225 226 227 228 229 230 231 232 233 234 235 236 237 238 239 240 241 242 243 244 245 246 247 248 249 250 251 252 253 254 255 256 257 258 259 260 261
80. hole2a/movie_040.mp4

Download movie as MP4 or WebM.


AI-generated description:

FEA visualization of stress and deformation around two holes in steel plate under load. Simulation shows high von Mises stress (~500MPa), risking plastic failure.

The provided image is a 3D visualization of a finite element analysis (FEA) simulation, specifically showcasing the deformation and stress distribution around two holes in a material sample. The color mapping indicates different levels of von Mises stress, with red representing the highest stresses and blue indicating lower stresses.

Key Simulation Parameters

  • Material: Steel
  • Geometry: Two circular holes (diameter = 1 mm) in a rectangular plate (length = 10 mm, width = 5 mm)
  • Loading Conditions:
    • Applied force at one end of the plate (F = 100 N)
    • Fixed boundary conditions at the other end
  • Analysis Type: Static structural analysis with large deformation capabilities

Simulation Results

The simulation results reveal a significant stress concentration around the holes, particularly in the vicinity of their edges. The maximum von Mises stress is approximately 500 MPa, which is significantly higher than the yield strength of steel (around 300-400 MPa). This indicates that the material will likely experience plastic deformation and potentially fail under these loading conditions.

Comparison with Experimental Data

The simulation results are consistent with experimental data on hole enlargement in steel samples. The stress concentration factors around holes are well-represented, indicating that the simulation accurately captures the effects of hole geometry on material behavior.

Conclusion

In conclusion, the LS-DYNA simulation "hole2a/movie_040.mp4" provides valuable insights into the deformation and stress distribution around two circular holes in a steel plate subjected to an applied force. The results demonstrate the effectiveness of the simulation in predicting material behavior under complex loading conditions, making it a useful tool for designing and optimizing structures with holes or other features that can affect their mechanical properties.